Make a Polka Dotted Pumpkin

This was a quick project that only took us about two hours including the drying time.  If you decide to try it, please share by tagging us @mainstreetcollection or use #MSCpolkadot.  We would love to see your pumpkin projects this season! 

Yes, we did and so can you!

Whenever my daughter is home from college we always have at least one art/craft project on the agenda and this Fall Break I was dying to take a drill to my pumpkins.  Caroline had volunteered at a children’s “Make It & Take It” art event at her college and said it was easy.  I figured if they could do it around kids, surely I could handle it.  So we did!

Here are the steps that we took and the items that we gathered before we began.

  • PUMPKIN (the bigger the better for me!)
  • Spray paint if you want a color & painter’s tape
  • Power Drill, Circle Drill Bit – 1 3/4″(Craftsman calls it a Hole Saw)
  • Newspaper
  • Knife and kitchen spoon to clean out the pumpkin
  • Safety goggles
  • Tape measure, pencil or Sharpie.
  • Tall pillar candle (4 to 5 inches tall)

Step 1: Wear old clothes and safety goggles because pumpkin bits and pieces will start flying when the drill hits that pumpkin. Definitely an outside project!

Step 2:  Wash pumpkin and let dry.  Put painter’s tape around the pumpkin stem to keep it the natural color. Spray paint your pumpkin on newspaper and let dry.

Step 3:  Cut a circle around the top of the pumpkin and pull gently on the stem to remove it from the pumpkin.  Clean out the seeds and pumpkin fibers. (SAVE the seeds for roasting!! YUM!)

Step 4:  If you want your polka dots to be uniformly placed on the pumpkin then use a tape measure and mark off where you want your polka dots placed.  We started at the top and placed a mark every 4 inches for the center of our polka dot.

(There are so many sizes of circle drill bits but I chose just one for my first time. I am definitely going back to get some other sizes so I can try another one with more random placement of the polka dots and sizes!!) 

Step 5:  We did re-spray paint a few areas of the pumpkin again after the drilling but it really is not necessary. (One of us is a perfectionist and one of us is not!)

Step 6:  We used a tall candle in the pumpkin to make it very bright. At first, we used a small votive candle and it did not give us enough light to brighten all of our polka dots so… I went back inside and found a taller, brighter candle.

This was a quick project that only took us about two hours including the drying time.  If you decide to try it, please share by tagging us @mainstreetcollection or use #MSCpolkadot.  We would love to see your pumpkin projects this season!

Happy Pumpkin Day!

Rae Marie

 

 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s